LED module

This module is a simple carrier board for attaching LEDs to any garment. Three LED footprints (3528, 0805, and two or four-pin through-hole) support most common LEDs, positions for current-limiting resistors allow you to set the brightness of the LEDs, and four three-wire ports provide a place to establish an electrical connection or sew the module to a garment. With or without an LED, the module can also be used as an expansion board to provide your garment with more three-wire power and communication lines. All four ports are connected to each other on the board, so by bringing one power, ground, and data line to the module, it can be split off in three directions.

Dimensions
0.8”x0.8”

Download Schematics
These schematics may be viewed and maniuplated using Eagle.
They are released under this Creative Commons license.